|
Who's Online
There currently are 5749 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This is a good quality scan of the Operation & Maintenance (Service) Manual for the PAL version of this high-band broadcast umatic, BVU-800P
All schematics and lineup procedures appear to be included in this one manual AFAICT.
The file size is just over 113 MB which gives an idea of the quality and number of pages.
All of the schematics, which contain some fairly small print, are easily readable when you zoom into the page.
John Thompson, Newcastle Upon Tyne, England.
;
Good quality, all schematics of few of models. There is also short form of user manual and regulation manual.
;
Perfect copy of the service manual. you can enlarge every page, and it comes up
with all details.
;
It´s very very nice manual with all, what i need. Original in good quality. Very fast business. Very much thanks...
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site.
Thank you very much
MODELS: WT-46809 / WS-55809 / WS-55819 / WS-65809 / WS-65819
SERVICING THE DIAMONDSHIELD� 1. DiamondShield� Removal Procedure
The location of the DiamondShieldTM molding clips varies between models, top and bottom, or sides. Use the appropriate disassembly procedure given below. Note: Wear gloves when handling the DiamondShield� to prevent finger prints.
Top & Bottom Molding Clips
Side Molding Clips
1. Gently insert a small screwdriver between the DiamondShield� and one end of the clip to pry the clip loose.
1. Gently insert a small screwdriver between the DiamondShield� and one end of the clip to pry the clip loose.
2. Remove both clips by pulling them toward you.
2. Remove both clips by pulling them toward you.
3. Carefully insert a small screwdriver into the gap at the top/center point of the Shield and pull the Shield slightly away from the unit. Place your hands at the points shown and gently bow the Shield toward you and remove from the unit. Then re-install the two clips.
3. Carefully insert a small screwdriver into the gap at the side/center point of the Shield and pull the Shield slightly away from the unit. Place your hands at the points shown and gently bow the Shield toward you and remove from the unit. Then re-install the two clips.
2. DiamondShield� Installation Procedure
*(See the Parts List for DiamondShield� part numbers) To install the DiamondShieldTM, reverse the above Removal Procedure.
Page 15
|
|
|
> |
|