The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
WD-73927
1) Remove (16) screws (A). 8 on each side. (Remove only the outside screws. Do not remove inside screws, they are for the Screen Frame) 2) Pull Front Panel Escushions from unit.
A
A
A
A
3) Remove (8) screws (B) and remove the Pedestal Cover. Mechanical adjuster is now accessable.
B
B
Locking Screws and Wedge Removal
Before mechanical adjustments can be made, locking screws must be loosened.
� �
[B-1] is located on the front of the UNIT-ADJUSTER. (Figure 1) In 52� and 62� models [B-2] is accessible from the rear of the unit on the right side of the Optical Engine (from the rear). (Figure 2) WARNING: DO NOT loosen [B-2] too far. The nut on the other side may drop off. Then then Optical Engine must be removed to re-install the nut.
[B-2]
Figure 2: 52� & 62� Side Locking Screw
Page 49