|
Who's Online
There currently are 5990 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927
DIAMOND SHIELD REPLACEMENT
(WD-62927 / WD-73927 Only)
To Remove the Diamond Shield: 1) While wearing soft cotton gloves, loosen the sides of the Diamond Shield by pressing a small plastic card (the size of a standard credit card or a clean, plastic, putty knife) into the middle of the side slot. The Diamond Shield side will snap out of the top, middle and bottom clips. Loosen both sides before proceeding to step 2. 2) After the sides are free, gently push down on the top of the Diamond Shield. It will slide out of the top channel. 3) Carefully pull the screen up to it from the bottom channel. Store the Diamond Shield in a clean dust free area, where it will not be scratched.
To Install the Diamond Shield: 4) Slide the Diamond Shield into the bottom channel, making sure it fits securely. 5) Press gently on the top of the Diamond Shield to slightly bow the screen toward you. Insert the top of the Diamond Shield into the top channel. It should fit securely. 6) At each side, gently press the top, middel and bottom of the Diamond Shield to snap it back into place.
WARNING
Sharp edges! Always wear gloves to handle, lift, install and remove the Diamond Shield.
Page 38
|
|
|
> |
|